Archive

Low-Viscosity, Melt Adhesive

March 17, 2005

Jet-melt 3750 adhesive is optimized for the high-volume, self-contained Polygun AE II Applicator.

The low-viscosity adhesive has a high flow rate for faster production and good hottack properties cures. It cures in 50 sec. The applicator can feed Jet-melt adhesive at 4 lb/hr, warms to 400°F in 3 min, and has a built-in stand to keep it upright.

3M,
3M Center, Bldg. 220-7E-01,
St. Paul, MN 55144,
(800) 362-3550, 3m.com

Continue Reading

Air Compressor Market Expected to Reach Nearly $69B by 2030

Creating a Device for Measuring Nanoparticles

Sponsored Recommendations

50 Years Old and Still Plenty of Drive

Dec. 12, 2024

After 50 years of service in a paper plant, an SEW-EURODRIVE K160 gear unit was checked. Some parts needed attention, but the gears remained pristine.

Explore the power of decentralized conveying

Dec. 12, 2024

Discover the flexible, efficient MOVI-C® Modular Automation System by SEW-EURODRIVE—engineered for quick startup and seamless operation in automation.

Goodbye Complexity, Hello MOVI-C

Dec. 12, 2024

MOVI-C® modular automation system – your one-stop-shop for every automation task. Simple, future-proof, with consulting and service worldwide.

Sawmill Automation: Going Where Direct-Stop and Hydraulic Technologies “Cant”

Aug. 29, 2024

Exploring the productivity and efficiency gains of outfitting a sawmill’s resaw line with VFDs, Ethernet and other automated electromechanical systems.